联系方式

  • QQ:99515681
  • 邮箱:99515681@qq.com
  • 工作时间:8:00-23:00
  • 微信:codinghelp2

您当前位置:首页 >> Python编程Python编程

日期:2020-11-24 09:28

BE491 Fall 2020 Lab 3 report outline

1

Lab 3: Signals, filters and the frequency domain

Formatting

? Single spaced

? 1 in margins

? Arial 11 for text, Arial 9 for captions

? Concise report (under 5 pages with figures)

? Correct grammar and spelling

? Answered questions in complete sentences/paragraphs

Figure format

? Figure captions

? Axes labeled

? Legend (when appropriate)

? Data lines/markers thicker than default

? All figure text legible and font sufficiently large

? Range for horizontal and vertical axes equivalent for all subplots within a figure

? Identify each subplot within a figure

Checkpoint code (10 pts)

Abstract (10 pts)

State the purpose

? Explain the relationship between the time and frequency domains

? Explain analog-to-digital conversion

? Explain how a filter works in the frequency domain

Describe the methods

? Arduino code

? Square waves, impulses

? Low-pass filter, high-pass filter

? FFT

Summarize the results

? Ability to measure frequency response using different methods

Abstract is ~300 words or less

Results (70 pts)

Section 1 – Characterizing filters with square waves (20 pts)

Describe the following. Refer to Figures 1 and 2 in the text to illustrate and support your points.

? How a filter can be characterized with square waves.

? The signals generated by the Arduino.

? The low-pass filter that was constructed and their cutoff frequencies.

? The data that were collected.

BE491 Fall 2016 Lab 4 Solutions

2

? How low-pass filters affect input waveforms and how this depends on waveform

frequency.

? The analysis used to examine waveforms quantitatively.

? The input waveforms in the frequency domain

? How the waveform’s FFTs change as a result of low-pass filtering.

Section 2 – Characterizing filters with impulses (20 pts)

Describe how filters can be characterized with impulses. Qualitatively describe the impulse

response of the low pass filter in the time domain and frequency domain, and how it depends on

the capacitor value (and thus, cutoff frequency). Refer to Figure 3 in the text to illustrate and

support your points.

Section 3 (20 pts) – Comparing estimates of the filter frequency response

Describe three methods for characterizing filters in the frequency domain and how they were

achieved. Qualitatively describe how the estimates of the frequency response of the low-pass

filters differ using each method. Refer to Figure 4 in the text to illustrate and support your

points.

Section 4 (10 pts) – Characterizing a high-pass filter

Describe the difference between low-pass and high-pass filters. Describe how square waves

are shaped by high-pass filters in the time domain as well as how they are changed in the

frequency domain. Refer to Figure 5 and 6 in the text to illustrate and support your points.

Discussion (10 pts)

Discuss the advantages of and disadvantages of describing filters in the frequency domain

using different methods. Use 300 words or less


版权所有:留学生编程辅导网 2018 All Rights Reserved 联系方式:QQ:99515681 电子信箱:99515681@qq.com
免责声明:本站部分内容从网络整理而来,只供参考!如有版权问题可联系本站删除。